Dual 4K HDMI® HDBaseT + VGA , 3.5mm, and RS232 over Cat Switching
Extender Box Transmitter - 4K 60Hz
Product Overview
Front Panel
1
2
4
3
F
P
D
RONT
ANEL
ESCRIPTION
1
USB Micro-B IN
Supports firmware updates through this port.
On: Power is applied to the device.
2
Power LED
Off: No power is applied to the device.
Blinking: The device is working properly.
3
Status LED
Off: The device is not working properly.
On: HDCP protected content is being transmitted.
4
HDCP LED
Blinking: Non-HDCP protected content is being transmitted.
On: HDBT link is normal.
5
Link LED
Off/Blinking: No HDBT link or link error.
On: Auto switching function is active.
6
Auto LED
Off: Auto switching function is inactive.
Blue: Select current channel
7
Input LED
Orange: Current channel has active signal
Purple: Select current channel and that channel has active signal
Transmitter
5
6
7
Rear Panel
8
9
R
P
D
EAR
ANEL
ESCRIPTION
8
VGA IN
Connect to a VGA source using a VGA cable.
9
AUDIO IN
Audio input, embedded with the VGA source.
10
Dual HDMI IN
Connect to HDMI sources using HDMI cables.
11
RS232
For RS232 device control.
12
HDBT OUT
Connect to the receiver via a Cat 5e/6/6a cable.
Connect the power adapter provided.
Note: The power adapter connected to either transmitter or
13
DC 18V
receiver is able to power on both units if receiver supports
bidirectional POC function.
2
Transmitter
12
13
10
11
(us)
(us)