ROADTRIP 52
GB
User manual
Operation
Roadtrip 52 is ready for use straight from the box when powering it
via the mains supply. For battery operation Roadtrip 52 must first be
charged for at least 8 hours. After this charging time, the internal bat-
tery modules reach their maximum capacity. Next, proceed as follows:
1) Next connect your external sources like a microphone or instru-
ment and/or a stereo line source with the Combo and RCA inputs
on the rear of Roadtrip 52. Please note that the input cables are
not supplied with the unit.
2) If required, pair Roadtrip 52 with an external Bluetooth device.
3) Turn on the UHF wireless microphone if necessary.
4) Connect the supplied power cord to the mains. Finally, use the
POWER switch to turn Roadtrip 52 on or off.
NOTE: Before you turn on or off Roadtrip 51, make sure to completely
pull down the MASTER VOL control to avoid any damages to the inter-
nal speaker due to turn-on/off pulses.
Information on battery operation
You can operate Roadtrip 52 while it is powered either by the mains
supply or the internal battery modules. When Roadtrip 52 is connected
to the mains supply, the battery modules are automatically charged.
The CHARGING LED informs you about the current charging status:
If the battery modules are charging, the CHARGING LED flashes.
If the battery modules are fully charged, the CHARGING LED is
constantly lit.
Before operating Roadtrip 52 with batteries for the first time, you have
to charge the device for at least 48 hours: this will optimize the char-
ging capacity and extends the battery's life.
Connection examples
UHF wireless
microphone
wired
microphone
or guitar
External Bluetooth device
(e.g. laptop or smartphone)
If the capacity of the internal battery modules is too low, Roadtrip
52 automatically switches off. In this case connect Roadtrip 52 to the
mains supply using the supplied power cord.
The battery modules may not be fully discharged. When not using
your sound system for a longer period, please fully charge the batte-
ries before. Roadtrip 52 must never be left in a discharged state for a
long time.
NOTE: When Roadtrip 52 has not been used for 2 months, please con-
nect it to the AC mains to charge the battery for at least 8 hours. The
battery shall not be exposed to excessive heat. Avoid direct sunlight
and do not operate Roadtrip 52 next to any heat sources.
Please do not attempt to open the back cover or power
adapter as opening or removing the covers may expose you
to dangerous voltage or other hazards. In addition, this will
void the warranty. There are no user serviceable parts inside.
CD player
10
www.nowsonic.com
WARNING!
Tape recorder or
other recording device