Activating/Deactivating Automatic Outputs; Remote Activation And Deactivation Of The Outputs; Monostable Outputs; Programming The Device - Bentel Security BGSM-100KCA Manual Del Usuario

Activating/Deactivating Automatic Outputs

The T1,T2 and T3 Open Collector outputs can be activated automatically by the following events:
 T1, land line trouble (line down)
 T2, GSM Network trouble (Limited/No Service)
 T3, caller identification
, , , , , Once an output has been activated automatically, it will not restore its state until all the causes of activation
clear.

Remote Activation and Deactivation of the Outputs

The T1 and T2 Open Collector outputs as BISTABLE, while the T3 output is MONOSTABLE (Once a Monostable output
has been activated, it will not deactive until On Time expires).

Monostable Outputs

The Monostable T3 output may be activated as follows:
1. By sending a cost-free call from a preset Remote Control number. This Device will activate the output concerned
without answering the call.
The ON time may be set to a period of time between 1 and 86400 seconds, in steps of 1 second.
, , , , , For proper function of this Device, use a 32 K SIM CARD (or higher).
For the programming using the PC-Link cable (see Fig. 5) must be connected to the Connector [9] of the Communicator and
a COM port on the PC; the BGSM-100 Console application is also required.
Once the PC-Link cable has been connected, set the computer COM port through the the Options->Serial ports
Fig. 5 - Diagram of the PC-Link connection cable
BGSM-100

PROGRAMMING THE DEVICE

G G G G G
25