Bentel Security BGSM-100KCA Manual Del Usuario página 20

5. Connect the wire [3] to the GSM antenna connector [4].
6. Complete the connections on the terminal blocks [10].
7. Following the arrow, insert the SIM-CARD [8] face down in the SIM holder [6] (see Figure 1).
! ! ! ! ! The SIM-CARD PIN must be disabled before the card is inserted into the transmitter.
8. Make sure that all the green LEDs flash when the product is switched on; this means the Communicator is in its initialisation
phase.
9. Checking Signal Strenght :
– make sure that at least one of the green LEDs remains lit; all green LEDs lit indicates perfect coverage;
– if the green LEDs are not illuminated, the signal strength is TOO WEAK; change the position of the antenna until you
find a position which offers acceptable signal strength, at least one LED illuminated.
10. Close the control panel cover.
, , , , , Connect power circuit only after the cabinet has been secured to the building or structure and has been
connected to the protective earth ground of the building.
! ! ! ! ! Before inserting or removing the SIM card, please ensure the unit is powered down.
Fig. 2 - Mounting of electronic card inside the control panel.
20
GSM/GPRS Alarm Communicator