General Description - StetSom IR400.1 Manual De Usuario

General description

1 2 3 4 5
1. LOW PASS FILTER (L.P.F.):
This variable control allows you to select
the final frequency from 60Hz to 22KHz that will be reproduced by the
amplifier.
2. HIGH PASS FILTER (H.P.F.):
This variable control allows you to select the
initial frequency from 10Hz to 700Hz that will be reproduced by the amplifier.
3. LEVEL:
Control of the signal level at the amplifier input that will be
sent to the audio output.
4. HIGH INPUT:
WIRE type connection for input of the signal to be
amplified. Connect to the radio / player via the harness included in the
kit. This input has the AUTO TURN-ON feature that allows the amplifier
to be triggered from the radio audio signal.
If the audio signal level of your radio is not sufficient to turn on the amplifier,
use the remote connector (REM) to turn on the product.
5. INPUT:
Input of the signal to be amplified. Connect to radio/player via
shielded, quality RCA cables to prevent unwanted noise.
9