Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION INSTRUCTIONS
When the oven is first connected to the electrical supply, wait for the display
automatically show " 12.30 ", a beep sound once and the " 12 " and " . " flash.
Ensure the correct time of the day is set before using the oven. Please note: that
is 24 hour clock, for example 2PM shown as 14.00.
To set the correct time of day
1> Press the "+" and "-" buttons at the same time to set the time.
2> Press the "
" button to confirm the time setting.
3> Press the "+" and "-" buttons at the same time to set the minutes.
4> Press the "
" button to confirm the minute setting and return to standby
status.
Note: if the display does not flash when you turn it on for the first time, you can
follow these steps to set the clock.
Oven On and Off
If the timer is in standby mode; press "
enter manual mode and the symbol "
1) Set the desired cooking function and temperature settings.
2) Set the timer and the oven will switch on.
If you set Dur or End, after cooking, the oven will automatically turn off.
If you set manual or minute minder, after cooking, bring the cooking
function and oven temperature knob to " 0 " position. Press "
buttons for more than 3 seconds to return to standby mode.
Time function setting
In manual mode, pressing "
of the function setting is Manual mode - Minute minder-Dur-End-Manual mode.
Then select the cooking function and adjust the cooking temperature if required.
Manual mode
In manual mode, only the current time is displayed and the symbol
nated. It is up to the user to control the cooking time.
In this mode, to ensure that the oven is not left on by accident, when 5 hours
elapse without any button being pressed, the timer will flash as a warning that
the oven is about to enter standby mode. After a total of 10 hours, it will enter
standby mode.
When the timer is flashing in manual mode, press any button to reset it if you
intend to continue using the oven, or press
least 3 seconds to enter standby mode if you are not going to use it any more.
" for more than 3 seconds, the timer will
" will light up continuously .
" can enter the time function setting. The sequence
7
and "+" at the same time for at
" and " + "
is illumi-
V.4
Publicidad
Tabla de contenido
