HoMedics WFL-SLMP-GB Manual Del Usuario página 4

WFL-SLMP-1110-01_IB_Layout 1 13/12/2010 12:28 Page 4
ASSEMBLY AND INSTRUCTIONS FOR USE :
1. Unpack the product. Wipe off dust with a damp cloth.
2. Familiarize yourself with the pump. The pump speed is controlled by the switch located at the
front of the pump. The speed is indicated by a plus (+) and minus (-) sign. To increase the
speed, move the switch slowly downward in the direction of the plus sign. At its highest speed
level, the switch will cease to move any further. To decrease the pump speed, move the switch
upward toward the minus sign. Similarly, at its lowest speed, the switch will cease to move any
further. NOTE: It is recommended the pump be set at its highest speed during assembly and
later adjusted to a lower setting if desired. Be sure to unplug the pump before adjusting the
speed setting.
3. Insert tube (located on the underside of the platform (B)) into the pump.
4. Insert tubes for each tier (A) to the corresponding holes on the platform (B) as shown in Fig. 1.
Note: Do not hold tiers, hold the tube under the tier for assembling.
5. Fill the fountain (C) with water to 1 inch from the top. We recommend using distilled water to
prevent mineral build up.
6. Set the platform with the assembled tiers onto the base on top of the notch so it sits level.
7. Attached the A/C adaptor jack (F) to the base power cord. DO NOT plug into the outlet at this
time.
8. Set the fountain on a level, waterproof surface.
9. Plug the cord into 230–240V mains outlet. The fountain is controlled by the switch located on
the power cord. If pump doesn't operate, rotate in-line switch once to turn "on" and once more
to turn "off". NOTE: Ensure that the electrical cord loops below the electrical outlet to form a
'Drip Loop' (Fig. 2). This will prevent water from running down the cord into the electrical outlet.
10.Arrange the river rocks provided on the platform and/or tiers. (if splashing occurs, rearrange
rocks until there is no more splashing).
Figure 1
A-Tiers with
Tubes
C-Fountain Base
D-River Rocks
B-Platform
Holes
E-Tube
Pump
Fill with water
Notch
Cord Slot
F-Adaptor
ON/OFF
Switch
4
Figure 2
Drip Loop