HoMedics BPA-060 Manual De Instrucciones página 11

1. Press the User-Select button to choose User 1
or User 2.
2. With the cuff wrapped around your arm, press the START/
STOP button. Do not inflate the cuff unless it is wrapped
around your arm. All digits will light up to check the display
functions. The checking procedure will be completed after
about 3 seconds.
3. After all symbols disappear, the display will show
"00". The monitor is "Ready to Measure" and will
automatically inflate the cuff to start measurement.
OR
19
4. The cuff will begin deflating as measurement continues.
Note: This monitor will re-inflate automatically if the
system detects that your body requires more pressure
for measurement.
5. When the measurement is completed, the cuff will
deflate entirely. Systolic pressure,
diastolic pressure and pulse will be
shown simultaneously on the LCD
screen. The measurement is then
automatically stored into memory.
Note:
1. This monitor automatically turns off approximately 1 minute
after last operation. You may also press the START/STOP
button to turn the unit off.
2. To interrupt the measurement, you may press the
START/STOP (recommended), "MEMORY," User-
Select or Date/Time Set (
deflate immediately after a button is pressed.
) buttons. The cuff will
20