Assembly - Cub Cadet CC1-TR Manual Del Operador

WARNING:
To prevent serious personal injury, never
operate the unit without the cutting head shield in place.
INSTALLING THE CUTTING HEAD SHIELD
1. Slide the rear shield section onto the back of the mount bracket
(Fig. 1). The shield section should slide into the groove (Fig. 1).
This may require a firm push.
2. Slide the front shield section onto the front of the mount bracket
(Fig. 2). The shield section should slide into the groove (Fig. 2).
This may require a firm push.
3. Align the holes in the rear shield section with the holes in the
front shield section (Fig. 3).
4. Insert the 2 screws through the aligned holes (Fig. 3). Turn the
screws until they are finger tight.
5. Using a flat-head or T20 Torx® screwdriver, tighten the screws
until the cutting head shield is firmly in place.

ASSEMBLY

Mount
Bracket
Groove
Mount Bracket
Front Shield
Section
Holes
6
Rear Shield Section
Fig. 1
Groove
Fig. 2
Screws (2)
Fig. 3