TZS First AUSTRIA FA-8006-3 Instrucciones De Uso página 3

OPTIONAL NORMAL WEIGHING MODE
(by passing parameter setting)
Auto step on weighing
1. 3.
2.
WARNING INDICATIONS
Low Battery Indication
The battery power is running low, please replace with a new battery.
Over-load Indication
The weighing subject on the platform exceeds the maximum capability of scale. Please
step off to avoid damage.
Low Fat% Indication
The Fat% is too low. Please lead a more nutritional diet and take good care of yourself.
High Fat% Indication
The Fat% is too high. Please watch your diet and do more exercise.
Re-test
Error exists, please re-test to get the correct result.
FAT/HYDRATION/CALORIE MEASURING MODE
(1) Setting personal parameters
1. At the first time when you install battery and switch on, all default parameter are set as follow:
Memory Gender Height
1 Male 165cm/5'05.0"
2. Parameters can be set in the following range:
Memory Gender Height
1~12 male/female 100~250cm/3'03.5"~8'02.5"
1. Install battery and place the
scale on flat floor
4.
2. Step on the weighing platform
3. Display your weight
4. Digits flash, stabilized and
locked
Age
25
Age
10~100
4
3. Parameter setting
Press
Press SET
Power off
to select
(ON/SET) to
Default
user code
switch on
parameters
Press SET (ON/
Press
SET) to confirm
to select
and prompt to
gender
next setting
Press
to set height
Press SET (ON/
Press
SET) to confirm
to set age
and prompt to
next setting
Power off
Auto off after several seconds
(2) To Start Measuring
Press SET
Power off
(ON/SET) to
switch on
Show parameters of
the last user or default
parameters
Weight readings
locked and flash once
Wait until the digits
stabilize
Measuring...
Measured results (Repeat for 3 times):
Weight: 52.8kg, Fat status, Fat 23.8%, Fat status i, Hydration 52.3%,
BMI 20,0, Calorie 1840.
Shut down automatically
Example: the 3rd user, female,
168cm, 28 years old, can set her
parameters as follow:
NOTE:
Press SET (ON/
• During parameter setting, if idle
SET) to confirm
for 6 seconds, the parameters
and prompt to
next setting already set will be memorized
automatically and LCD shows
„0", meaning body fat measuring
will be started.
• If LCD prompt to show „0"
during parameter setting, press
SET (ON/SET) for 3 seconds
to return setting mode, then
you can set user code, gender,
height and age
Tap on the
scale platform
LCD shows „0.0"
(Make sure
your feet are
Press
touching with
metal
to select user code
or reset parameters
electrodes on
Tap on the
the scale
scale platform
platform, or
body fat can
Step onto weighing not be
platform gently
measured.)
To ensure
(both feet touching
accuracy,
with metal
LCD shows „0.0"
electrodes)
please remove
your shoes &
socks before
stepping on.
Example:
the 3rd user,
female, 168cm,
28 years old
can measure
as follow:
5