Installation - HOMEDEPOT Everbilt ZE00802A Manual Del Usuario

Installation

1
Priming water
Add water (approximately 1-2 Tbsp.) into the inlet to wet the

impeller of the pump (A).
3
Attaching the suction hose to the
pump inlet
Thread the other end of the suction hose (C) to the suction inlet

of the pump (A).
Always ensure the washer in the hose bib is
NOTE:
not damaged. An airtight seal is necessary for this
pump to operate.
Make sure the suction hose (C) and suction strainer (B) are in
the water before plugging in the pump (A).
2
Attaching the suction hose to
strainer
Attach the clear suction hose (C) to the suction strainer (B) by

pushing the male threaded end into the rubber coupler on the
suction strainer.
Then, place the strainer in at least 1/2 in. of water at the lowest

point to be pumped.
Make sure the connection is airtight. An air
NOTE:
leak can cause the pump (A) to run dry.
4
Attaching the discharge hose to
the pump outlet
Thread a 5/8 in. or larger garden hose (sold separately, 50 ft.

max. length) onto the discharge outlet of the pump (A).
Make sure the end of the outlet hose is not
NOTE:
under water. If the outlet is under water, the pump
may not work.
5
Please contact 1-844-241-5521 for further assistance.
HOMEDEPOT.COM