Operating - HOMEDEPOT Everbilt ZE00802A Manual Del Usuario

Installation (continued)
5
Attaching the pump to a sturdy
base
Attach the pump (A) to a sturdy base (table, board, etc.) to prevent

it from tipping over. Make sure the hoses are as straight as
possible.
WARNING: This pump CANNOT be submersed in
water, and the motor CANNOT get wet at all. Getting the
motor wet could cause electrocution, which could lead to
serious injury or death!
Do not coil or kink the hose.
NOTE:
If the pump is allowed to run dry for too long, the pump's overheat protection will automatically shut the pump off. To use the pump again,
after the motor temperature decreases (wait at least 30 minutes), you must unplug and re-plug in the pump.
6

Operating

To operate, plug the pump (A) into a GFCI outlet.

This pump can be very loud when plugged in.
NOTE:
THIS IS NORMAL. Once water begins to pump, the
noise will dissipate. When the water level has been
reduced to approximately 1/8 in., you MUST UNPLUG
THE PUMP. DO NOT RUN DRY. The pump will be
EXTREMELY LOUD when the pump is no longer
pumping water.
If water is not pumped in 30 seconds, unplug
NOTE:
the power cord and check the connection on the two
ends of the inlet hose to make sure there are no air
leaks. Then, add water into the inlet again and repeat
the process.
6