Installation Steps - AVS Ventvisor Instrucciones De Instalación

Ocultar thumbs Ver también para Ventvisor:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Steps

Clean the painted surface where the visor will
mount with an alcohol pad.
1
Align front visor with previously cleaned surface.
3
Apply pressure to secure visor to vehicle.
5
NOTE: Actual application may vary slightly from illustrations.
Peel back 2" of tape liner from back of front visor at
top flange
2
Remove remaining tape liner.
4
Clean the painted surface on the rear door
surface where the visor will mount with an
6
Page 2 of 3
each end of top flange.
rear
flange
front
flange
alchohol pad.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

9232677092326

Tabla de contenido