Descargar Imprimir esta página

General Wiring Diagram - BFT ERGO Instrucciones De Uso Y De Instalacion

Publicidad

FIG. 12
I
PREDISPOSIZIONE DELL'IMPIANTO ELETTRICO
SCHEMA GENERALE
I)
Interruttore generale di linea con fusibili di protezione da
5A.
L)
Lampeggiante con antenna
M)
Motoriduttore
D)
Scatola di derivazione
A)
Antenna con cavo caossiale
S)
Selettore a chiave da fissare nella facciata esterna del
pilastro.
P)
Pulsantiera da interno, per più pulsanti collegare in paral-
lelo.
FTi-Fte) Fotocellula trasmittente interna ed esterna da fissare ad
una altezza compresa tra 40 e 60 cm.
FRi-FRe) Fotocellule riceventi interna ed esterna da fissare ad una
altezza compresa tra 40 e 60 cm.
Pa)
Pressostato per costa pneumatica di apertura.
Pc)
Pressostato per costa pneumatica di chiusura.
N.B.: la sezione e il numero di fili é indicata nel disegno (fig. 12).
Per lunghezze superiori a 100 mt. aumentare la sezione dei
fili.
- Tutte le masse metalliche dei contenitori delle apparecchiature e
degli automatismi devono esser messe a terra.
- Le fotocellule e i pressostati devono essere collegati tra loro in
serie con contatto normalmente chiuso.
GB
ELECTRICAL SYSTEM WIRING DIAGRAM

GENERAL WIRING DIAGRAM

I)
Main circuit breaker with 5 A protection fuses.
L)
Flasher with antenna
M)
Reduction gear unit
D)
Junction box
A)
Antenna coaxial cable
S)
Key switch must be mounted on exterior of gate post.
P)
Pushbutton panel for interior mounting - extra panels can
be connected in parallel.
FTi-Fte) Interior and exterior photoelectric cell transmitter, must
be mounted at a heigh between 40 and 60 cm.
FRi-FRe) Interior and exterior photoelectric cell receiver, must be
mounted at a height between 40 and 60 cm.
Pa)
Pressure switch for pneumatic skirting (open phase).
Pc)
Pressure switch for pneumatic skirting (close phase).
N.B.: the gage and number of wires is indicated on drawing in
figure 12 - for lenghts greater than 100 m. increase gage of
wire.
- All ground wires of all equipment and casing must be grounded.
- The photoelectric cells and the pressure switches must be con-
nected together in series with contact normally closed.
7

Publicidad

loading