Control Panel; Channel Control Section - Yamaha MX 200-8 Manual De Operación

Control panel

■ Channel control section

A
B
20dB
–16
GAIN
PEAK
80
–15
HIGH
–15
MID
–15
LOW
0
AUX 1
0
AUX 2
0
AUX 3
0
AUX 4
L
PAN
ON
PFL
2
Downloaded from: http://www.usersmanualguide.com/
1
2
3
–60
4
5
+15
6
+15
+15
10 P
R
E
10
7
P
10
O
S
T
10
8
R
9
0
10
5
0
5
10
15
20
30
40
A
00
1 Input selector
This button selects the input connector for the channel.
When A ( ) is selected, the input signal will be taken from the rear
panel INPUT A connector (balanced XLR type). When B (
selected, the input signal will be taken from the rear panel INPUT B con-
nector (balanced phone jack).
2 PAD switch
This pad switch provides 20dB of level reduction.
If the input signal level is too high and the 3 GAIN control will not
reduce it sufficiently, use this pad switch.
3 GAIN control
According to the level of the input signal, use this knob to adjust the input
to an appropriate level.
The best balance of S/N and dynamic range will be achieved if you adjust
the GAIN control so that the 4 peak indicator lights occasionally. If you
wish to further reduce the input level, use the 2 PAD switch.
4 PEAK indicator
This indicator detects peak levels after the EQ.
It will light red at 3dB before clipping to warn that clipping level has
nearly been reached.
5 80Hz high-pass filter switch
This switch turns on/off a high-pass filter that cuts the signal below 80Hz
at 12dB/octave.
6 Equalizer
The equalizer section provides ±15dB of control over the high, mid and
low ranges at the following frequencies.
HIGH: 12kHz
MID: 2.5kHz
LOW: 80Hz
Frequency response will be flat when the knob is at the "▼" position.
+20
+15
+10
+5
0
–5
–10
–15
–20
20 50 100 200 500 1k 2k 5k 10k 20k
FREQUENCY (Hz)
) is