Yamaha MX 200-8 Manual De Operación página 5

7 AUX1–4 controls
These knobs control the level of the signals sent to the
AUX buses.
• The AUX1 and AUX2 controls are pre-fader, and the
signal levels sent to the AUX 1 and 2 buses will be un-
affected by the channel fader setting.
• The AUX3 and AUX 4 controls are post-fader, and the
signal levels sent to the AUX 3 and 3 buses will be af-
fected by the channel fader setting.
8 PAN (panpot) control
This knob assigns the signal of each channel to the
STEREO L, R bus, determining the stereo position of the
sound.
9 Channel ON switch
When this switch is on, the signal of each channel will be
sent to the STEREO L, R bus and the AUX1–4 buses.
When this switch is off, the output signal to each bus will
be muted completely. This switch should be turned off for
unused channels.
INPUT A
1-*
INPUT B
1-*
Downloaded from: http://www.usersmanualguide.com/
PHANTOM
OFF
(+48V)
ON
(INPUT A)
PHANTOM
(PHANTOM)
PAD HA
A
20dB GAIN
B
*=8,12,16,24
0 Channel PFL switch
This switch allows you to monitor the pre-fader channel
input signal through headphones.
It is convenient to use PFL when you wish to check the
sound of the input signal, or when troubleshooting a
specific channel.
A Channel fader
This fader controls the output level of the input channel
signal, determining the volume balance between channels.
The channel fader should be lowered for unused channels.
PEAK
INPUT CH
INSERT I/O
0dB 1-*
3BAND
HPF EQ
ON
80
(+V)
PAN
AUX 1
AUX 2
AUX 3
PFL
3