Horizon Global 65084 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
Conical Washer
Teeth side
Against hitch
Fasteners
typical
both sides
NOTE: Requires trimming of lower fascia for hitch installation. Obtain owner permission before trimming.
1. Remove factory bolts – Using 24mm socket and open-end wrench, remove (2) M16 factory bolts from vehicle frame, both sides. (Caution: Once the (2) M16 factory bolts are removed it is
possible the bracket could separate from vehicle frame. If bracket is loose, then remove from vehicle frame until installing hitch). Using 18mm socket and open-end wrench remove (1)
M12 factory bolt from vehicle chassis, both sides. Return factory bolts to vehicle owner.
2. Trim lower fascia – Using a utility knife, trim center section of fascia opening. This piece of the fascia will be completely removed and discarded. Next trim a 3" x 3" square below center,
see Figure 2.
3. Install hitch – Raise the hitch and loosely secure it at forward holes on the chassis with (1) M12 bolts, (2) conical washers, and (1) M12 nut ⑤③③⑦, both sides, see Figure 1. Install (2)
M14 bolts, (4) flat washers, (2) lock washers and (2) M14 nuts ①④④⑥② with bracket and chassis, both sides, see Figure 1.
Note: If there is a gap between hitch bracket and mounting surface, use (1) extra flat washer ④ on both M14 bolts, see Figure 1.
4. Tighten all M14 CL8.8 fasteners with torque wrench to 100 Lb.-Ft (136 N*M).
Tighten all M12 CL8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M).
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged
should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2020 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 65084, CQT65084
①④
⑤③
Rearward
Figure 1
④ Optional
④⑥②
③⑦
Figure 2
Sheet 3 of 12
Fastener Kit: 65084F
①
Qty. (4) Bolt M14 x 2.00 x 120 CL8.8
②
Qty. (4) Nut M14 x 2.00 CL8
③
Qty. (4) 1/2" Conical Washer
④
Qty. (12) 9/16" Flat Washer
⑤ Qty. (2) Bolt M12 x 1.75 x 120 CL8.8
⑥ Qty. (4) 9/16" Lock Washer
⑦ Qty. (2) Nut M12 x 1.75 CL8
℄
2.00"
3.00"
3.00"
65084NP 08-03-20 Rev. A