Replacing The Battery; Lid Positioning - Open Or Close; Testing For Gas Leaks - Teka TBBQ 4100 G SS Manual Del Usuario

REPLACING THE BATTERY

Unscrew the electrical ignition button and remove the old battery. Replace with new AA battery.
Note: The negative (-) side of the battery goes in first. Please refer to the mark on the side of the cap.
LID POSITIONING – OPEN OR CLOSE
Cooking with the lid open or closed is a matter of personal preference.
• LID OPEN
Cooking with the lid-open is recommended if you enjoy cooking at maximum searing temperatures. This method
will also produce more flare-ups, speed the cooking procedure and will give you a more robust, smoky, outdoor
flavor. Lid-open when grilling meats, especially chicken.
• LID CLOSED
If you prefer cooking slower with less flare-up, we suggest the lid-closed method. Perfect for indirect or rotisserie
cooking. We recommend always cooking with the lid CLOSED if you are in a windy area or colder climate.
Your grill has been designed and constructed to give you maximum flexibility and cooking performance. Be creative.
Try different cooking methods on your grill to determine which suits your needs best. There is no right or wrong way to
cook, just alternative cooking styles. Get creative and enjoy!
CAUTION: Always protect your hand with a pot mitten or cooking glove when coming into contact with a hot surface.

TESTING FOR GAS LEAKS

Warning! Risk of explosion!
Never use a match or open flame for leak detection. Use of an open flame could result in fire, explosion and
bodily harm.
Test all connections, fittings and all gas hoses for gas leaks every time prior to use of the appliance, or each time the gas
cylinder is changed. Make sure this procedure is carried out in a well-ventilated area away from flames, sparks or any
heat sources. Do not attempt to light the appliance, if you smell gas.
1. Make sure that all control knobs on the appliance are in the off positions (OFF).
2. Open the gas valve of the gas cylinder and / or the pressure regulator.
3. Apply leak detector spray or half water / half soap solution with a brush to all the connection points.
4. If you spot gas bubbles forming, there is a leak. Turn the gas supply and/or the pressure regulator off immediately.
Tighten all connections again and repeat the test.
5. Do not use the appliance but contact your retailer, if gas bubbles keep forming.
IMPORTANT: When connecting or replacing any gas pipe or fittings, all joints must be sealed with approved leak-
proof sealing compound or plumber's tape.
EN-22