Aligning The Appliance; Connecting The Appliance - Bosch B21CL80SNS Instrucciones De Uso

Aligning the appliance

NOTICE
To ensure that the appliance operates correctly, use
a level to align the appliance.
If the appliance is not level, water may flow out of the
ice maker, ice cubes may be irregular, or the doors
may not close properly.
1. Place the appliance in the designated location.
2. So that the appliance cannot move, unscrew the
two front feet until they are standing firmly on the
floor.
3. Screw the feet in/out until the appliance is exactly
level.
4. Use the level to check if the appliance is level.
NOTICE
To ensure that the appliance does not move, the
front feet must be firmly planted on the floor.
5. If the height of the refrigerator compartment doors
are uneven or if the freezer compartment drawer is
slanted after adjusting the level of the appliance,
use the following method to adjust them.
Adjusting the refrigerator doors
The appliance must be level in order to get the doors
to align.
1. Raise the lower door up to the level of the higher
door.
2. Insert the supplied fastener-ring (A) using a pair of
pliers (B) in the gap between the
hinge-grommet (C) and the lower hinge (D). The
number of fasten-rings you will need to insert
depends on the gap.
Installing the base plate
1. Mount the base plate.
2. Insert the three screws and tighten (the screws are
located in the manual kit).

Connecting the appliance

Have a technician install and connect the appliance
according to the enclosed Installation Instructions.
Do not remove the transportation protection devices
from the shelves and storage compartments until the
appliance has been installed and aligned.
Always connect the water before the power.
Apart from statutory national regulations, you should
comply with all applicable local electricity and water
companies' codes and requirements.
After installing the appliance, wait at least 6 hours
before switching the appliance on. During
transportation the oil in the compressor may have
flowed into the refrigeration system.
Before switching the appliance on for the first time,
clean the interior of the appliance (see chapter
"Cleaning the Appliance").
en-us
B
C
A
D
7