Cequent Performance Products 65059 Instrucciones De Instalación

FRAME
Hitch Shown In Proper Position
Equipment Required: Bolt leader (Provided)
Fastener Kit: 65059F
Wrenches: 18MM DEEP WELL, 7/8"
Drill Bits: 1/2"
Other Tools: Tape, Cutting tool for hard
Plastic fascia.
TRIM FASCIA AS SHOWN
This is a magnified
5
view of a Bolt Leader
j
Carriage Bolt, 1/2" -13 x 1 1/2" Gr5
Qty. (4)
l
1/2" Helical lock washers
Qty. (4)
1. It is necessary to trim a section out of the plastic fascia attached to bottom of bumper. See Picture
above.
CONSULT VEHICLE OWNER BEFORE TRIMMING OR CUTTING PLASTIC AIR DAM.
2. Locate and remove the18mm flange nuts on outside of truck frame rails, slide the bolt plate back into
frame but do not remove.
CAUTION: DO NOT completely remove bolt plate, if removed bumper will drop and may result in injury.
3. Raise hitch into position, slide bolts plates back thru frame and into hitch side brackets. Loosely install
nuts removed in Step 2.
With front Bolts in use rear holes as a guide to drill (4) 1/2" holes into frame.
4.
Use 1/2" bolt leaders to pull 1/2" carriage bolts and spacer blocks thru the frame and through the hitch
5.
as shown (FIG.2). Square shoulders of bolts must be pulled into blocks to engage with the sides of
frame. Check to see that carriage bolt is engaged in block holes. Install helical lock washers and hex
nuts as shown.
6. Tighten flange nuts and torque all hardware to the specs specified below.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2012 Cequent Performance Products
Front Mounted Receiver
FASCIA
Installation Instructions
Dodge 3500
¼" TOP AND BOTTOM
FIG.2
Frame rail
Tighten all 1/2" fasteners with torque wrench to 75 Lb.-Ft. (101.7 N.M.)
Tighten all M12 fasteners with torque wrench to 92 Lb.-Ft. (124.7 N.M.)
(V-8 GASOLINE ONLY)
CARGO CAPACITY – Do not exceed
Gross Axle Weight Rating, (GAWR).
9,000lb.
Bolt
Plate
3 4
k
Block 1/4" x 1-1/2" x 2
Qty. (4)
m
Hex Nut, 1/2"
Qty. (4)
Sheet 1 of 65059N
Part Numbers:
65059
500 LB (227 Kg.) or Truck Front
MAXIMUM WINCH LINE PULL
FIG.1
Bolt
leader
08/21/12
Form: F205 Rev A 5-6-05
2 1
Rev. B