How To Use - IRIS IC-SB1U Serie Manual De Instrucciones

WALL MOUNT INSTALLATION
Using Screws
When the adhesive sheet cannot be used, do not peel off the paper backing on
the wall mount . Instead, screw the wall mount into the wall as shown .
How to Store the Vacuum
Place the body vertically against the wall so the top is at the wall mount .
Cord hook (top)
Magnet
The vacuum body can be attached to the
wall mount with the magnet.
Please place the vacuum as
close as possible to the wall
and stand upright.
Do not place on anything other than the wall mount . Vacuum may fall .
CAUTION
Be sure to store vertically . Vacuum may fall down if stored at an angle .
Screw hole
Wall mount
Main body
7

HOW TO USE

1 Insert the power plug.
Be sure the power is set to OFF
CAUTION
before inserting the power plug into
the outlet .
2 Turn the vacuum on.
Turn the power to ON to start the vacuum .
3 Turn the vacuum off.
Turn the power to OFF to stop the vacuum .
4 Unplug the vacuum.
Unplug the power plug from the outlet .
Before disconnecting the power plug, be sure the power is set to OFF .
When unplugging the vacuum, do not pull on the power cord . Always unplug holding the power
CAUTION
plug .
Do not leave the vacuum plugged in when finished . Be sure to unplug the power plug from the
outlet .
ON/OFF Switch
ON/OFF Switch
ON/OFF Switch
8