Assembling The Vacuum; Charging The Vacuum - Simplicity S5 El Manual Del Propietario

ASSEMBLING THE VACUUM

Charging the Vacuum

NOTE: The battery charger must be
connected to the electrical outlet
for charging.
The vacuum is partially charged and will
run for a short time. We recommend fully
charging the vacuum before use.
1. Set the vacuum onto the Storage/
Charging Station, ensuring the
connection between the points
on the vacuum with the Storage/
Charging Station (Fig. 1).
2. Plug the battery charger into the
Storage/Charging Station and
into an electrical outlet (Fig. 2).
The indicator light on the vacuum
will blink red while the battery
is charging. When the indicator
light is green, the battery is fully
charged (Fig. 3). Charging time is
approximately 3 hours.
3. Remove the vacuum from the
Storage/Charging Station and begin
vacuuming.
4. Unplug the battery charger when the
vacuum is in use.
5. Always return the vacuum to the
Storage/Charging Station when not
in use.
Charging Indicator Light
Blinking Red = Low Battery
Blinking Red = Charging
Solid Green = Fully Charged
Blinking Green = Fault
(see Troubleshooting)
4
Fig. 1
Fig. 2
Fig. 3