Settings; Manually Set Clock; Room Size; Spray The Aroma Manually - Oregon Scientific WA328 Manual Del Usuario

SETTINGS

You can customize your required settings prior to the start of the unit diffusing.

MANUALLY SET CLOCK

To set the clock on the main unit:
1. After the power adapter is plugged in, lift the top of the main unit. Press
rear of the main unit, the main unit automatically enters to clock setting mode.
2. The setting sequence is 12/24 hr format, hour and minute.
3. Press to change the settings slowly, or press and hold
change the settings.
4. Press to confirm setting.

ROOM SIZE

You can adjust the strength of the aroma according to the size of the room where the device is located. The time
interval between each spray depends on the size of the room. It usually takes approx. 5-minutes per spraying cycle.
1. Press to enter setting mode.
2. Slide ft /m switch to select a measurement unit.
2 2
3. Press to adjust the room size; the setting sequence is 10m
(~100ft , 200ft , 300ft , 400ft
2 2 2 2
4. The setting will automatically be saved.

SPRAY THE AROMA MANUALLY

You can select a desired nozzle to spray the aroma manually.
1. Make sure the aroma oil filled into the bottle for spraying.
2. Press at the top control panel to change the nozzle.
3. When selecting the nozzle, there will be a light indication on the side of the selected nozzle.
4. The setting sequence is Right Nozzle, Left Nozzle and Stop (no light).
5. The setting will automatically be saved.

OIL DIFFUSION INTENSITY

You can set up your desired aroma oil diffusion intensity, you have three options.
1. Press on the top control panel to select intensity:
2. The setting will automatically be saved.

MOOD LIGHT

Your aroma diffuser has a colourful mood light in the base of the unit. You can select
one colour or set all of the colours on a loop.
1. Press on the top control panel, you can select OFF, 01 (red), 02 (pink), 03 (orange),
04 (yellow), 05 (green), 06 (blue), 07 (purple) and LOOP. The colour will light up, as you are selecting.
2. The setting will automatically be saved.

CUSTOMIZE AROMA OIL DIFFUSION PROGRAM

You can customise two programs (P1/P2) for two different schedule.
To activate & deactivate a program:
1. Press P1/P2 to activate the program. P1/P2 will be displayed on the LCD.
2. Press P1/P2 to turn the program OFF.
To set a program:
1. To setup a program.
2. Press and hold P1/P2 to enter setting mode.
3. When the nozzle indicator is flashing, press
Press P1/P2 to save the setting and enter next step (aroma oil diffusion intensity setting).
, 20m
2
and 500ft ).
2
(intensive),
to select your desired direction.
at the
to rapidly
, 30m , 40m and 50m
2 2 2 2
(medium) and (low).
03