Maintenance And Service - Bosch PCM 7 S Manual Original

OBJ_BUCH-1270-001.book Page 37 Thursday, July 22, 2010 12:44 PM
Sawing Profile Strips
Profile strips/mouldings can be sawn in two dif-
ferent ways:
– Placed against the fence
– Lying flat on the saw
table
In addition, the cut can be perfomed with or
without slide movement depending on the
width of the profile strip/moulding.
Always make trial cuts with the mitre angle set-
ting first on scrap wood.
Transport (see figure P)
Before transporting the power tool, the follow-
ing steps must be carried out:
– Bring the machine into the transport posi-
tion.
– Insert the saw-table extensions 14 into the
power tool's front openings 28.
– Remove all accessories that cannot be
mounted firmly to the power tool.
If possible, place unused saw blades in an
enclosed container for transport.
– Carry the machine by the transport handle 24
or hold it by the recessed grips 27 on the
sides of the saw table.
When transporting the power tool, use only
the transport devices and never use the
protective devices.
Bosch Power Tools

Maintenance and Service

Maintenance and Cleaning
Before any work on the machine itself, pull
the mains plug.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
Cleaning
For safe and proper working, always keep the
power tool and its ventilation slots clean.
The retracting blade guard must always be able
to move freely and retract automatically. There-
fore, always keep the area around the retracting
blade guard clean.
Remove dust and chips after each working pro-
cedure by blowing out with compressed air or
with a brush.
Clean the roller 6 regularly.
Accessories
Saw blades for wood and plate materials,
panels and strips/mouldings
Saw blade 190 x 30 mm,
40 teeth . . . . . . . . . . . . . . . . . . . 2 609 256 821
Saw blade 190 x 30 mm,
12 teeth . . . . . . . . . . . . . . . . . . . 2 609 256 868
Saw blade 190 x 30 mm,
24 teeth . . . . . . . . . . . . . . . . . . . 2 608 640 615
Saw blade 190 x 30 mm,
60 teeth . . . . . . . . . . . . . . . . . . . 2 608 641 188
1 609 929 W43 | (22/7/10)
English | 37