Troubleshooting - Black and Decker BDCDB18 Manual Del Usuario

ENGLISH
Installing and removing the battery (Fig. B)
Warning! Make certain the vac is switched off before
removing or installing battery.
To install battery pack
Insert battery pack into the vac until an audible click is
u
heard (Figure B). Make sure battery pack is fully seated
and fully latched into position.
To remove battery pack
Depress the battery release button (6) as shown in Figure
u
B and pull battery pack out of the vac.
Operation
Warning! This product is for dry pick-up only.
To switch the vac on, slide the on/off switch forward
u
(Fig. C).
To switch the vac off, slide the on/off switch backward
u
(Fig. C).
Assembly
Remove the dust bowl (3) by pressing the dust bowl
u
release button (2) and pulling the bowl down and out
(Fig. D).
Remove the filter by pulling it out of the dust bowl (Fig. E).
u
Install the filter into the dust bowl by aligning the filter
u
triangle with the dust bowl triangle and placing it firmly into
position as shown in figure E.
Note: It is very important that the filter is correctly in
position before use.
To install the dust bowl, place it back onto the front of the
u
unit and click firmly into position.
Mounting accessories
The brush tool (8) has a brush that can be used for dust-
u
ing and upholstery cleaning.
The crevice tool (7) allows for vacuuming in narrow and
u
hard to-reach places.
To attach an accessory, press the accessory into dust
u
bowl (3).
Cleaning the product
Warning! Never use this cordless hand vacuum
without its filters.
Note: The filter is re-usable, do not confuse them with dispos-
able dust bags, and do not throw it away when the product is
emptied. We recommend that you replace the filter every 6-9
months.
Warning! Maximum dust collection will only be obtained with
clean filters and an empty dust bowl. If dust begins to fall back
out of the product after it is switched off, this indicates that the
bowl is full and requires emptying.
6
(Original instructions)
Remove the filter and shake or lightly brush any loose
u
dust off the filter.
Empty the dust from the bowl and wash if necessary.
u
Wash the filter regularly using warm, soapy water as
u
shown in figure F. Ensure that it is completely dry before
using again.
Note: The cleaner the filter is, the better the product will
perform.
The dust bowl can also be washed in warm soapy water
u
as shown in figure F. Ensure that it is dry before re-
attaching.
Never immerse the product in water. A damp cloth and
u
soapy water should be used to clean the exterior of the
motor section. Always ensure the product is completely
dry before re-use or storing.

Troubleshooting

Problem Possible Cause
Unit will not start. Battery not installed
properly.
Battery not charged.
Battery will not charge. Battery not inserted into
charger.
Charger not plugged in.
Surrounding air
temperature too hot or
too cold.
Maintenance
Your BLACK+DECKER corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
Switch off and unplug the appliance/tool.
u
Possible Solution
Check battery
installation.
Check battery charging
requirements
Insert battery into
charger
until LED appears.
Plug charger into a
working
outlet. Refer to
"Important
Charging Notes" for
more details.
Check current at
receptacle
by plugging in a lamp
or other appliance.
Check to see if
receptacle is
connected to a light
switch which turns
power off when you
turn out the lights
Move charger and tool
to a surrounding air
temperature of above
4,5°C or below
+40,5°C.