Conceptronic CH3B2E Manual Del Usuario página 19

ENGLISH
When you have created or changed the harddisk configuration of your unit, it is advised (and in some cases
required) to format your new created configuration before use.
You can follow the format instructions below to format your harddisk.
Note : The format instructions below are based on Windows Vista. When formatting in a different version
of Windows, the steps below can vary.
• Click on the "Start" button and select "All Programs", "Accessories", "Run".
• Enter the command "diskmgmt.msc" (without the quotes) and click "OK" to run the command.
The Disk Management tool of Windows will appear on your screen.
• Select your new harddisk configuration from the bottom section of the list.
• Right click your new harddisk configuration and select "New Simple Volume".
• The Format Wizard will appear on your screen. Click "Next" to continue.
• Select the size for your new harddisk configuration. By default, the maximum size is specified. If you
want to create multiple volumes on your harddisk configuration, reduce the size to the required size of
your first volume. If you want to create 1 volume, keep the maximum size. Click "Next" to continue.
• Select which drive letter you want to assign to the new volume. By default, the first available drive
letter is shown. Click "Next" to continue.
• Select your format options. You can change the file system, change the volume label and choose for
"Perform a quick format". Click "Next" to continue.
6. Formatting your harddisk
19