Replacing The Battery - Conceptronic CUPS600 Manual Del Usuario

English

Replacing The Battery:

 Use a cross-type screwdriver to remove the two front panel screws and
slide down the panel.
 Gently Pull the battery out of the UPS.
 Loosen the black wire from the negative (-) terminal and red wire from
the positive (+) terminal.
 Connect the battery leads to the new battery.
 Note: Small sparks at the battery connectors are normal during
connection.
 Slide the battery into the UPS.
 Close the front panel and fasten two screws.
 Dispose of the old battery properly at an appropriate recycling facility.