4. Insert split lag bolt through holes in the end of the
anchor and secure loosely with nuts. (See Figure 3)
Figure 3
Split Bolt
5. Insert the strap over the frame under the foot plank.
The buckle of the strap should end just below the
bleacher frame and thread through buckle.
(See Figure 4)
Figure 4
6. Slide the strap through split bolt. (See Figures 5-6)
NOTE: Split bolt can be used in either hole
and from either side.
Figure 5
PAGE 2 OF 9
INSTRUCTIONS CONTINUED
Nut
Foot
Plank
Strap
Strap
Figure 6
7.
Slide the end of the strap through the buckle, pull
out slack and tighten. Repeat for other end.
(See Figure 7)
Galvanized
Anchor Strap
Figure 7
8. Tighten nuts.
9. Cut excess strap.
Strap
Anchor
Strap Head
1"
0721 IH-4415