Descargar Imprimir esta página

Trust AC-1000 Manual De Instrucciones página 3

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 8
AC-1000 MAINS SOCKET SWITCH
EN
1. Connect lamp/device and place receiver
First check if the lamp or device is turned on. Then plug the lamp or device into the receiver and plug
the receiver into a socket. Do not exceed the maximum load: 1000 W.
2. Activate learn-mode
Press the learn-button on the receiver for 1 second. The learn-mode will be active for 15 seconds,
during which the LED-indicator will blink slowly.
3. Assign transmitter code
Send an ON-signal with any Trust SmartHome transmitter while the learn-mode is active, to assign the
code to the receiver's memory.
4. Code confirmation
The receiver will switch on/off 2 times to confirm the code has been received. The receiver can store
up to 6 different transmitter codes in its memory.
The memory will be preserved when the receiver is moved to another socket or in case of power
failure.
5. Manual operation with a Trust SmartHome transmitter
1. Press ON to switch the receiver on.
2. Press OFF to switch the receiver off.
6. Single code delete
1. Press the learn-button for 1 second. The learn-mode will be active for 15 seconds, during which
the LED-indicator will blink slowly.
2. While the learn-mode is active, send an OFF-signal of a specific TRUST SMART Home transmitter to
delete that code.
3. The receiver will switch on/off 2 times to confirm code deletion.
1
7. Full memory delete
1. Press and hold the learn-button of the receiver (approx. 7 sec.) untill the LED-indicator starts
blinking fast. The delete mode will be active for 15 seconds.
2. Press the learn-button again for 1 second while the delete mode is active.
3. The receiver will switch on/off 2 times to confirm memory deletion
AC-1000 MAINS SOCKET SWITCH
EN
2

Publicidad

loading