Trouble Shooting; Fault Correction - Deltafox DG-EHT 6860 3D Traducción Del Manual De Instrucciones Origina

Trouble Shooting

Problem
Device does not
start
Device runs with
interruptions
Blades ( 2)
become hot
Possible cause
Mains voltage not on
On/Off switch (
tive
Worn carbon brushes
Defective motor
Power cable is damaged
Internal loose electrical con-
nection
On/Off switch (
tive
Blades ( 2) are blunt
Blades ( 2) are notched
Too much friction due to
lack of lubrication

Fault correction

Check plug socket, cable, line and
plug, where appropriate, have re-
paired through electrical specialist
8) defec-
Repair by Service Centre
Check the cable and have it changed
by the Service Centre if necessary
Repair by Service Centre
8) defec-
Have the blades (
replaced (Service Centre)
Have the blades (
replaced (Service Centre)
Oil the blades (
GB
2) sharpened or
2) checked or
2)
63