Ferm SGM1013 Traducción Del Manual Original página 5

Specific safety instructions
Safe handling of the machine is only
possible when you read the safety and
operating instructions thoroughly and
rigorously follow the instructions which
are included inside.
Warning: The soldering iron must be
placed in its holder when not in use
• For all work on the soldering station, pull the
plug out of the socket.
• The power supply lead and the plug must be
in perfect condition. Always keep the power
supply lead away from the area of work.
• The voltage of the electric power source must
tally with the instructions on the type plate of
the appliance.
• Always fasten the nut tightly when attaching the
tip. This ensures a good electric connection.
• Ventilate the place of work sufficiently in order
to take unwanted vapours quickly away from
melting material.
• The mains power supply lead for the soldering
gun may only be replaced by a specialist
electrician.
• Use only original accessories which
are supplied or recommended by the
manufacturer.
• Do not immerse the unit in liquids of any kind.
• Do not use the unit to heat plastic or liquids.
• Never use the device on live electronic circuits.
Make sure power to the work piece is cut and
capacitors are discharged.
• Incorrect use may cause fire.
• Do not touch the shafts, tips, or hot air gun as
this can cause serious burns. Keep the tips
and hot air away from the body, clothes, or
other flammable material.
• Always let the device cool down after use and
before storage.
• Place the device on a level, stable, and fire
resistant working surface.
Immediately unplug the soldering gun in case of
• The soldering gun is overheated.
• Malfunction of the mainsplug, socket or
damaged cables.
• Broken switch.
• Smoke or smell caused by scorched insulation.
During first time use the soldering iron may
produce some smoke, this is grease used in
manufacturing burning off.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Mains connection
Only use earthed sockets with earthing wire
connected per the regulations.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm2. When using a cable
reel always unwind the reel completely.
The extension cords you use must always be
earthed.
3. OPERATING
Use this appliance only for work which is
included in the established operative
range.
• Mount the iron holder (5) onto the station and
put the soldering iron (3) in its holder.
• Lightly moisten the sponge [8] with some tap
water.
• Mount the appropriate soldering tip (1)
according to the soldering job (see below
Replacing the Tip).
• Place the station onto a heatproof, flat and solid
surface. Connect the soldering station to the
mains and switch on with the on-off switch (4).
• Turn the temperature adjustment knob (7) to
5