How To Use - Panasonic SR-Y22FGJ Instrucciones De Funcionamiento

HOW TO USE

Measure rice with the provided Measuring Cup. One cup of uncooked rice
makes approximately 2 cups of cooked rice. Rice should be leveled with
the brim of the Measuring Cup as shown in figure. Wash rice in another
bowl until water becomes relatively clear.
Put washed rice in the Pan. Refer to the markings on the Pan.
e.g. To cook 6 cups of rice, put the rice into the Pan and
then add water to the LEVEL INDICATOR 6.
Adjust water quantity to your taste.
Set the Pan in the Rice Cooker. To place correctly on the Heater, turn
the Pan gently to right and left. Cover with the Lid and let rice soak
approximately 30 minutes.
Plug in. The Power indicator Lamp lights.
Do not plug in until ready to cook.Otherwise, the Rice Cooker will turn into "Keep Warm" function and rice may be spoiled.
If you do not set the Pan in the Rice Cooker, the Switch cannot be pressed.
Press the Switch. The "Cooking" indicator (Orange) shows you cooking has started.
When rice is done, the Switch will pop up. The "Keep Warm" indicator changes to orange to signal "Keep
Warm" function is working.
After the Switch pops up, leave the Lid covered for at least 15 minutes to steam rice.
Then mix the rice well by using the Scoop to allow water vapour to escape (especially when cooking
towards maximum quantity).
Unplug after use. Grasp the Power Plug, not the Power Cord.
8
LEVEL
INDICATOR
2.2 12
10
1.8
8
1.4
6
1.0
4
MAX. LEVEL :
Do not cook more
than this amount.
Pan