Instructions For The Slope Adjustment; Adjusting The Folding Arms - sunfun 20030281 Manual Original

GB
Français
– Install the two gear lugs (12) on the
sliding elements (13) of the two
folding arms (6) using a Phillips
screwdriver (► p. 5, fig. H).
Instructions for the slope
adjustment
NOTICE! Risk of property
damage! Make sure that the
awning is only 1/3 extended
when you adjust the slope
angle (► p. 5, fig. I). Never
adjust the slope angle when the
awning is extended (► p. 5,
fig. J). Otherwise, the awning
may become damaged.
– To do this, use the crank (5) to
move the awning to the adjustment
range (► p. 5, fig. G) height. Hook
the crank on the second gear lug
(12) and turn it clockwise and then
counter-clockwise to change the
slope angle (► p. 5, fig. K).
– Make sure to set the same slope
angles on both sides of the awning
(► p. 5, fig. L).
Note: The drop profile (4) must
be horizontal. To make sure
that both sides are completely
horizontal, there is a built-in
spirit level on the front side:
– Make sure that the air bubble is
exactly in the middle of the spirit
level.
– Now you can use your awning.
Always remove the crank (5) after
use and store in a safe and dry
place.
134
NOTICE! Risk of property
damage! Never completely
close the awning if you have set
the maximum angle of slope.
First reduce the angle of slope
angle before closing the awning
completely.

Adjusting the folding arms

– It is important that the folding arms
(6) are parallel to each other for the
proper and safer handling of the
awning. Fully retract the awning
and check the folding arms (6). You
must readjust the folding arms (6)
manually (► p. 6, fig. M) if they are
not parallel to each other. Proceed
as follows:
– Extend the awning by approx. half
of its range► p. 6, fig. N). Make
sure that the awning is extended so
far that the upper hexagon socket
screw for the sliding element (13) is
visible (► p. 6, fig. O).
Note: The folding arm must
always be relieved before turn-
ing the adjusting screw, other-
wise the awning will be dam-
aged!
– Turn the hexagon socket screw (ø4
mm) in the direction of rota-
tion[ ]using a hexagon wrench to
adjust the folding arm (6) upward
(► p. 6, fig. O). Press the folding
arm (6) slightly upwards.
– Turn the hexagon socket screw (ø4
mm) in the direction of rota-
tion[ ]using a hexagon wrench to
adjust the folding arm (6) down-
wards (► p. 6, fig. O). Press the
folding arm (6) slightly upwards.