Product Description; Specifications; Components - Steelcase Migration SE Manual Del Usuario

_______________________________________________________________
3

Product description

Dimensions and weight specifications of your product
can be found on the delivery note.

3.1 Specifications

Dimensions and weight
Temperature range at the
setup location
Relative humidity
Input voltage range
Frequency range
Maximum load capacity
Maximum "ON" duration
Input current
Maximum adjustment range:
single telescope (Lift 1)
Double telescope (Lift 2)
Noise emission
Max. power consumption
during lifting
Power consumption in
standby mode
Up/Down control panel
Memory control panel
Type plates are located on the controller housing, on
the columns and under the desktop near the control
panel.
Type plate: symbols – explanation
Double insulation. Double insulated
cables minimise the risk of electrical
shock.
For indoor use. Indicates that
placing the product outdoors is not
allowed.
CE marking. Used to symbolise the
conformity of the product with the
applicable requirements that the
European Community places on the
manufacturer.
153310
Migration SE Desk &
Bench
See delivery note
+5°C to +35°C
5% to 80% (non-condensing)
220 to 240 V ˜
50 to 60 Hz
75 kg
2 min. ON/18 min. OFF
2.5 A
720 mm to 1200 mm
650 mm to 1250 mm
<60 dB (A)
240 W
≤ 0.2 W
Standard
Optional
Recycling symbol. Used to indicate
conformity with the regulations for
Waste Electric and Electronic
Equipment (WEEE) and the Electrical
and Electronic Equipment Act
(ElektroG). Electrical and electronic
products must be disposed of
separately from household waste at
the end of their service lives.
The CE marking is located on the underside of the
desktop and can be viewed at any time.

3.2 Components

The Migration SE Desk & Bench essentially
consists of the following components (the variant
descriptions can be found in the respective
chapters):
Desktop with plastic parts for desktop mounting
■
Software-supported and hardware-supported
■
stopping device with a sensor for system
protection
Migration SE Desk: Columns with bolted
■
65x25x2 mm steel pipe runner, including
adjusting screw to compensate for floor
unevenness, cable duct (optional)
Migration SE Bench: Columns without runners,
■
including adjusting screw to compensate for floor
unevenness, cross-member (welded), central
cable duct (optional).
Top plastic cap, left/right
■
Top cantilever, left/right (optional)
■
Horizontal structural profile section
■
Fixed height vertical variant
■
Optional electrical height adjustment:
■
Lift 1: Electric motor (720 to 1200), in
–
column, including software-supported
stopping device and sensor
Lift 2: Electric motor (650 to 1250), in
–
column, including software-supported
stopping device and sensor
Power lift for lifting height adjustment
–
Standard: Up/Down control panel
–
Optional: Memory control panel with display
–
for height indication; function for
programming four desktop heights
All available components can be found in the
separate technical description and the price list.
Product description
5