General Troubleshooting And Fault Clearance - Bonsaii DocShred Pro 8 Manual De Uso

General Troubleshooting and Fault Clearance

Fault
The device does not
operate
Cutting mechanism
blocked
Cutting mechanism
doesn't stop
Operating noise is
too loud
If the measures above don't help, please contact your Bonsaii dealer.
Fault analysis
Is the electrical connection at the
device and at the socket correct?
Collection container correctly
positioned?
Is the power cable damaged?
Might the motor have overheated?
Is the symbol flashing?
Is the paper too thin to be
recognised by the sensors?
Are you trying to shred too much
paper at once?
Paper jam?
Are pieces of paper or extraneous
material blocking the sensors?
Is the surface uneven? Is the
device standing upright?
Correct the plug connections.
Correct the fit of the collection container.
Replace the power cable or contact your
Wait until the device has cooled down.
Fold the paper or use the manual insert, " " .
Reduce the amount of paper and try again.
Switch to reverse operation, " " and remove
Remove the pieces of paper and try again.
Position the device on a flat surface.
18
Fault correction
Bonsaii dealer.
the excess paper.