Descargar Imprimir esta página

Polaroid Splash II Manual De Instrucciones página 4

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
Thank you for buying this 2 in 1 compact camera. Before using, please read this manual carefully to
ensure correct use.
Loading the Batteries
1. Open the Battery Compartment by sliding the latch on the Battery Compartment
Door to the direction of the arrow. (Fig. 1)
2. Gently lift up on the Battery Compartment Door. (Fig. 1)
3. lnsert two AAA alkaline batteries into the Battery Compartment, checking that
the (+) and (-) on the battery are aligned according to the polarity
information shown on the contact plate. (Fig. 2)
4. Close the Battery Compartment Door by pushing it back until it latches.
About the Film Speed
The Camera is designed to use DX-coded ISO100 or 400 fi lm. When the fi lm is
loaded, the camera automatically sets the correct fi lm speed by reading the black-
and-silver pattern on the fi lm cassettes. If DX-coded ISO 200 fi lm is loaded, fi lm speed
will be set to ISO400. If non DX-coded fi lm is loaded, fi lm speed will be set to ISO100
automatically.
Loading the Film
1. Open the Film Compartment Door by pressing upward on the Film Door Latch and
gently lift up the Film Compartment Door. (Fig. 3)
2. Insert the fi lm into the Film Compartment, and pull out the fi lm leader to reach the
Film Tip Mark. (Fig. 4)
3. Make sure the fi lm perforations engage the fi lm Sprocket Gear, and the fi lm lies
515216-EN 3
-3-
8/17/04, 9:51:25 AM

Publicidad

loading