Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
IMPORTANT NOTE: Type of pedal set detected when it is connected
to a Thrustmaster® racing wheel base via the RJ12 cable
(T150 / TMX / T300 / TX / TG-T / TS-XW / TS-PC)
Your Thrustmaster racing wheel base is compatible with two types of pedal sets (via the
RJ12 port):
T2PA 2-pedal sets and T3PA and T3PA-PRO 3-pedal sets
(Potentiometric type - low resolution)
T-LCM pedal set
(magnetic and load cell type - high resolution)
With the latest firmware update
different modes:
• T2PA / T3PA / T3PA-PRO MODE
• T-LCM MODE
(*)
To
get
this
firmware
https://support.thrustmaster.com/ click on Racing Wheels and select your racing wheel. In the Firmware
section, follow the instructions and procedure for downloading and installing the update.
How to visually identify the pedal mode stored in the internal
memory of your racing wheel base:
Look at the LED on the racing wheel base.
Each time you restart the racing wheel (during the self-calibration phase) or
each time you plug the pedal set into the RJ12 port of the base unit:
T2PA / T3PA / T3PA-PRO MODE
The LED will not flash 10 times.
), the base can now manage these pedal sets in two
(*
update
for
your
racing
4
wheel
base:
on
a
T-LCM MODE
The LED will flash 10 times.
computer,
go
to
Publicidad
