LaserLiner DigiLevel Laser Manual Del Usuario página 8

Read the operating instructions and the enclosed brochure
!
„Guarantee and additional notices" completely. Follow the
instructions they contain. Safely keep these documents for
future reference.
Digital electronic spirit level with vertical and horizontal angle
display. Additional line laser 635 nm.
General safety instructions
Caution: Do not look directly into the beam. Lasers must be kept out of
reach of children. Never intentionally aim the device at people. This is a
quality laser measuring device and is 100% factory adjusted within the
stated tolerance. For reasons of product liability, we must also draw your
attention to the following: Regularly check the calibration before use, after
transport and after extended periods of storage. We also wish to point
out that absolute calibration is only possible in a specialist workshop.
Calibration by yourself is only approximate and the accuracy of the
calibration will depend on the care with which you proceed.
Inserting batteries:
Open the battery compartment (16) on the rear of the DigiLevel and
insert two new batteries (type AAA/LR03) in the manner indicated
by the installation symbols. Ensure correct polarity. The symbol (10)
indicates the level of battery charge.
Switching on and measuring:
The DigiLevel Laser can measure angles continuously to 360°.
• Switch the DigiLevel Laser on using the on/off switch (2).
• The current operating temperature in °C is shown for a few seconds.
• The slope angle is shown in the display (8). If slopes are measured
overhead, the direction of display adjusts automatically.
• The current slope direction is also shown by the symbol (7).
Selection of unit of measurement:
• Button (5) allows the desired unit of measurement to be selected
(° degrees, %, IN/FT)
08
GB
Laser radiation!
Do not stare into the beam
or observe it directly
with optical instruments.
Laser class 2M
EN 60825-1:2007-10