Cleaning And Maintenance - MSW DG750 Manual De Instrucciones

If you notice any irregularities after starting the
engine, immediately turn off the device, check
the condition of the air filter, and the levels of
diesel oil and engine oil. If all these elements
are correct, contact the manufacturer's service
centre.
9. Loading the generator set
a) Electrical diagram of the generator set load
b) Loading:
• start the device
• increase the engine speed to the rated value
(engine speed lever turned upwards)
• check that the voltmeter shows 230V ± 10%, then
the device can be loaded
PLEASE NOTE: Do not start the generator when
the receiving devices are connected. When
the generator is loaded, the receivers should
be turned off. The devices connected to the
generator must be started individually. There
should not be more than two receiving devices
running simultaneously. The devices should be
connected in such a way that it is possible to
relieve the load immediately in case of incorrect
operation of the device; the indications of the
voltmeter should be monitored.
Note: When connecting devices to the generator,
make sure all the devices are less rated than the
generator output. No generator socket should be
overloaded above the limit provided.
10. Switching off the generator
• disconnect the electrical load from the generator,
• let the generator to work without load for about
3 minutes,
• turn on the generator main switch,
• when using the electric starter, turn the key to the
"OFF" position.

3.3. CLEANING AND MAINTENANCE

a) Use only non-corrosive cleaners to clean the surface.
b) After cleaning the device, all parts should be dried
completely before using it again.
c) Store the unit in a dry, cool place, free from moisture
and direct exposure to sunlight.
d) Do not spray the device with a water jet or submerge
it in water.
e) The device must be regularly inspected to check its
technical efficiency and spot any damage.
f) Use a soft cloth for cleaning.
g) Do not leave the battery in the device if it will not be
used for a longer period of time.
14
h) Use a soft, damp cloth for cleaning.
i) Do not use sharp and/or metal objects for cleaning
(e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
j) Do not clean the device with an acidic substance, agents
of medical purposes, thinners, fuel, oils or other chemical
substances because it may damage the device.
ENGINE OIL FILTER
Every 6 months or every 500 hours of operation, clean (or
replace if necessary) the oil filter. After changing the filter, it
is also recommended to change the oil.
FUEL FILTER
To ensure maximum output power, clean the fuel filter
every 6 months or every 500 hours of operation, and
replace it once a year or every 1000 hours of operation. In
order to clean or replace the filter:
• drain the diesel fuel from the tank
• loosen the screw of the fuel valve and remove the
filter from the fuel filler opening
• wash it thoroughly with clean diesel fuel and place
it in the fuel tank.
BATTERY
It is recommended to check the electrolyte level in the
battery once a month. If the level drops to the lower mark,
distilled water should be added so that the level reaches
the upper mark. The battery should be charged once
a month, and the charge level should be checked regularly
- especially if the device is used only as a backup source
of energy.
MAINTENANCE AFTER LONG PERIODS OF STORAGE
If the generator is stored unused for a long time:
• run the device without load for about 3 minutes,
• turn off the device, drain the oil and fill it in with
the clean oil,
• unscrew the rubber plug at the cylinder head and pour
2ml of engine oil into the cylinder, tighten the plug.
Frequency
Action
Check/top up the
O
diesel fuel
O
Drain the fuel
Rev. 19.10.2020
Check/top up the
O
engine oil
O
Leakage check
Check all fastening
O
elements
O
Changing the engine
O
the first
oil
replace-
ment
Cleaning the engine oil
O
filter (replacement if
necessary)
More often when
Cleaning / replacing
O
used in dusty
the air filter
environments
O
Cleaning the fuel filter
Injection pump
O
inspection
Fuel injection nozzle
O
check
O
Fuel line inspection
Adjustment of
clearances on the
O
intake and exhaust
valves
Checking the intake
and exhaust valves
Checking the
electrolyte level in the
Once a month
battery
SAFE REMOVAL OF BATTERIES AND RECHARGEABLE
BATTERIES
Remove used batteries from the device using the same
procedure by which you installed them. Recycle batteries
with the appropriate organisation or company.
DISPOSING OF USED DEVICES
Do not dispose of this device in municipal waste systems.
Hand it over to an electric and electrical device recycling
and collection point. Check the symbol on the product,
instruction manual and packaging. The plastics used to
construct the device can be recycled in accordance with
their markings. By choosing to recycle you are making
a significant contribution to the protection of our
environment. Contact local authorities for information on
your local recycling facility.
Rev. 19.10.2020
O
15