Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Read the instructions, keep them safe, pass them on if you pass the appliance on.
Remove all packaging before use.
IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
This appliance can be used by persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been
supervised/instructed and understand the hazards involved.
Children must not use or play with the appliance. Keep the appliance and
cable out of reach of children.
Always disconnect the appliance from the mains supply socket if it is left
unattended and before assembling, disassembling or cleaning.
Misuse of the appliance may cause injury.
If the cable is damaged, it must be replaced by the manufacturer, its service
agent, or someone similarly qualified, to avoid hazard.
•
Don't put the motor unit in liquid.
•
Don't use the appliance for any purpose other than those described in these instructions.
•
Don't use accessories or attachments other than those we supply.
•
Don't operate the appliance if it's damaged or malfunctions.
PARTS
1.
Whisks
2.
Hooks
3.
Eject button
4.
Speed control
5.
Turbo button
6.
Motor unit
BEFORE USING FOR THE FIRST TIME
•
Remove any packaging material and labels.
•
Wash everything except the motor unit and stand in warm, soapy water. Rinse and dry.
•
Wipe the motor unit and stand with a damp cloth.
•
Place the appliance on a dry, firm, level surface, near a power socket.
FITTING THE WHISKS/HOOKS
1.
Switch off and unplug the mixer before fitting or removing the whisks/hooks.
2.
One whisk and one hook is fitted with a plastic gear. These must be fitted in the right hand opening
R
marked
(FIG A).
3.
Turn each whisk or hook to align the pips on the shaft with the slots in the drive head, then push it
into the drive head till it clicks into place.
4.
Use both whisks or both hooks, don't mix them.
To remove the whisk/hooks:
1.
Switch the appliance off and unplug it.
2.
Hold both whisks/hooks, to prevent them jumping out, and press the eject button. This will eject
them from the drive heads.
USING THE HAND MIXER
1.
Move the speed control to O.
2.
Put the plug into the power socket.
3.
Move the speed control to the speed you require (1 to 5).
4.
Pressing the turbo button will over-ride the speed set by the speed control, and give you a burst of
high speed. It only works when the motor is already running (1 to 5).
HOUSEHOLD USE ONLY
7.
Arm
8.
Mixer lock button
9.
Arm release button
10. Stand
11. Bowl
` dishwasher safe
3
Publicidad
Tabla de contenido
