Bimar ZKX40A7 Folleto De Instrucciones página 27

control system, to avoid the risk of fire if the
appliance is covered or not correctly positioned.
• Warning: always keep the water in the tank between
the minimum and maximum level. During operation,
the tank must always be inserted in its place.
• Do not use abrasive detergents or sharp metal
scrapers to clean the oven glass door/hinged lid
glass (as applicable), as they can scratch the surface
and thus cause the glass to break.
• Do not use steam jets to clean the appliance.
• WARNING: Make sure that the appliance is switched
off before replacing the bulb to avoid the possibility
of electric shock.
INSTALLATION
• After removing the packaging, check that the appliance is intact; if in doubt, do not use it and
call in qualified staff. Packaging components (plastic bags, expanded polystyrene, nails, etc.)
must not be left within reach of children since they are potentially hazardous; dispose of them
in accordance with the current law.
Warning: any stickers or advertising leaflets applied to the door, or protective film, must be
removed before the appliance is used.
• Before connecting the appliance, check that the voltage values marked on the nameplate are
the same as those of the electrical mains, and that the power socket is properly earthed (the
manufacturer declines all responsibility arising from failure to comply with this rule). If the
appliance's plug is not compatible with the socket, have the socket replaced with another of
suitable type by qualified staff, who must ensure that the socket's wire gauge is suitable for
the appliance's power draw. Check that there are no other appliances drawing large amounts
of power on the electrical line, to avoid overloads and fire risks. In general, the use of adapters
and/or extension leads is not recommended; if their use is unavoidable, they must comply
with current safety regulations and their current rating (amps) must be no lower than the
maximum current draw of the appliance.
• Before each use, check that the appliance is in good condition and ensure that the power
cord is not damaged and do not switch it on unless certain it is intact: if in doubt, call in
qualified staff.
• Place the appliance:
- well away from other heat sources (e.g. other ovens, gas hob, etc.), flammable materials
(upholstery, etc.), explosive materials (spray cans) and materials which may warp in heat.
27