Bimar ZKX40A7 Folleto De Instrucciones página 37

Guideline for Troubleshooting
Abnormal
conditions
Open circuit for top sensor
E01
Short circuit for top sensor
E02
Open circuit for bottom
E03
sensor
Short circuit for bottom
E04
sensor
Open circuit for
E05
evaporating heater
sensor
Short circuit for
E06
evaporating heater
sensor
1. Check whether the
No display
power supply plug
on the
is plugged;
screen
2. Display panel in poor
contact
Oven lamp
1. Oven lamp is damaged
does not light
2. Poor contact
1. Poor contact
Fan does not
2. Fan is damaged
work
1.PCB is failed or damaged;
No response
2.Control panel Just time
from the
button
LED flash, other buttons no
response;
Water pipe is blocked
1.
Evaporator heater is
No steam
2.
damaged
Water intake
3.
system is
damaged
1. Door is not closed tightly
Steam oven
2. Poor contact of door
does not
control switch
work
1. Door is not closed in place
2. Door sealant is off or
Steam
damaged
leakage from
3. Oven release steam when
oven door
steam pressure is too big, it
is normal;
Possible causes
Stop the work, open the oven door and allow the cavity
to cool down for 10 minutes, and then restart it or
contact the after-sales service.
Stop the work, open the oven door and allow the cavity
to cool down for 10 minutes, and then restart it or
contact the after-sales service.
Stop the work, open the oven door and allow the cavity
to cool down for 10 minutes, and then restart it or
contact the after-sales service.
Stop the work, open the oven door and allow the cavity
to cool down for 10 minutes, and then restart it or
contact the after-sales service.
Contact the after-sales department for repair
Contact the after-sales department for repair
1. Re-energize;
2. Contact the after-sales department for repair
1. Replace or contact the after-sales department for
repair
2. Contact the after-sales department for repair
1. Replace or contact the after-sales department for
repair
2. Contact the after-sales department for repair
1. Replace control PCB
2. Be sure the water tank have water and tank is put into
Oven;
Contact the after-sales department for repair
1. Re-close the oven door;
2. Be sure the water tank have water and tank is put into
Oven;
1. Push door by hand
2. Replace sealant or contact service Department;
37
Solution