Porter Cable 543 Manual De Instrucciones página 12

Choose a convenient starting point. Hold
the bayonet saw over the point and inside
the line of waste. Tip the machine forward
until the front edge of the base rests firmly
on the surface of the workpiece with the
tip of the blade clear of the work surface,
(Fig. 8).
Turn the motor "ON" and slowly lower
the back of the machine until the base
seats on the surface. Guide the cut along
the inside of the marked area. If sharp
corners are desired, cut to the corner of
Fig. 8
the marked edge. Stop and back up just
a bit. Start the turn and cut along the side.
Do the same at each corner until you come back to your starting point.Cut into
each corner from the opposite direction.
BASE ADJUSTMENT
You can adjust the base in two ways: front to rear or left to right. The base has a
detent at the 0 (90°) setting and at 15°, 30°, and 45°, setting both left and right of
center.
The base was set at its forward-most position at the factory. You can adjust it
to the rear for making flush cuts. To move the base forward or backward, turn
the saw on its side, loosen the screw (A) Fig. 9, move the base to the desired
position, and retighten the screw.
NOTE: When making bevel cuts, set the base to the forward-most position,
(Fig. 9).
Fig. 9
A
12