HIKVISION DS-KIS703-P Manual De Instrucciones

DS-KIS703-P
Video Intercom Two-Wire Bundle
UD17634B-A
DS-KV8103-IMPE2
E N G L I S H
Video Intercom Villa Door Station
Appearance
1
1 Microphone 2 Calling Indicator 3 Speaking Indicator
4 Open Door Indicator 5 Built-in Camera 6 Supplement Light
7 Loudspeaker 8 TAMPER 9 Call Button
2 Terminals
A1 NC1 : Normally Close A7 AIN2 : Alarm Input 2
AIN1 : Alarm Input 1
A2 A8
NO1 : Normally Open
A3 A9 12V OUT : Power Output for Lock
COM : Common Interface
A4 NC2 : Normally Close A GND : Grounding
10
NO2 : Normally Open
A5 A 11 2-WIRE: Wire to Indoor Station
GND : Grounding
A6
Installation
3
To install the door station onto the wall, you are required to utilize a matched gang box.
The dimension of gang box is shown.
The door station supports surface mounting and flush mounting.
Before you begin:
1. Make sure the device in the package is in good condition and all the assembly parts
are included.
2. Make sure all the related equipment is power-off during the installation.
3. Check the product specification for the installation environment.
4. Connect cables to the door station before mounting.
Surface Mounting with Gang Box
1. Take the gang box and screws from the packing box.
2. Fix the gang box onto the wall with 4 screws.
3. Install the door station into the gang box, and fix it with 4 screws.
Flush Mounting with Gang Box
1. Cave the installation hole, and pull the cable out.
Note: The suggested dimension of the installation hole is 103.5 mm × 162.5 mm × 40.5
mm.
2. Insert the gang box into the hole with 4 screws.
3. Install the door station into the gang box, and fix it with 4 screws.
Getting Started
4
Wire the door station to the indoor station with 2-wire cables.
You can activate the door station by indoor station.
Set the open duration and other parameters by indoor station.
Refers to the Indoor Station Configuration Guide for details.
The application of the device is shown.
Video Intercom Operation
5
You can call the resident by pressing the call button.
1. Press the call button of the door station.
2. The resident can receive/decline the video call, unlock the door, etc.
Note:
When the video intercom between you and the resident is realized, you can speak to the
resident, and the live view of door station will be displayed on the connected indoor
station.
When the door station is calling the resident, the door station will detect the brightness
of video automatically. When the brightness is lower than the expected threshold, the
supplement light will be enabled.
When the supplement light is enabled, the backlight of key will be auto-enabled,
otherwise, the door station will detect the brightness of live view and enable the backlight
of key when the brightness of live view is lower than expected threshold.
Refers to Video Intercom Villa Door Station User Manual(scan the QR code) for details.
FCC Information
Please take attention that changes or modification not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
FCC compliance: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with a minimum distance 20cm between the radiator and
your body.
Please take attention that changes or modification not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
EU Conformity Statement
This product and - if applicable - the supplied accessories too are marked with "CE" and
comply therefore with the applicable harmonized European standards listed under the RE
Directive 2014/53/EU, the EMC Directive 2014/30/EU, the RoHS Directive 2011/65/EU.
2006/66/EC (battery directive): This product contains a battery that cannot be disposed of as
unsorted municipal waste in the European Union. See the product documentation for
specific battery information. The battery is marked with this symbol, which may include
lettering to indicate cadmium (Cd), lead (Pb), or mercury (Hg). For proper recycling, return
the battery to your supplier or to a designated collection point. For more information see:
www.recyclethis.info
2012/19/EU (WEEE directive): Products marked with this symbol cannot be disposed of as
unsorted municipal waste in the European Union. For proper recycling, return this product to
your local supplier upon the purchase of equivalent new equipment, or dispose of it at
designated collection points. For more information see: www.recyclethis.info
1
1
2
3
4
3
103
83
3
3
Screws Door Station
Screws
2
5
A1
6
NC1 NO1 COM
7
LOCK1
8
9
4
40
Door Lock
Power Supply
Unit:mm
1
2
Junction Box Wall
A11
NC2 NO2 GND AIN2 AIN1 12V GND 2-WIRE
OUT
LOCK2 ALARM IN
LOCK POWER
Door Station Indoor Station
Power Supply
3
Screws
Door Station Screws Gang Box
APP Control
Multicore cable
2-wire cable
Internet
Wi-Fi
1
2
Wall