KS LEV Ci Manual De Instrucciones página 19

AFTER SETTING SEATPOST ORIENTATION IN YOUR FRAME
Once you have oriented your LEV Integra seatpost within your
seat tube ensuring the saddle is aligned to point forward, you will
need to install your saddle. Remove the two saddle head clamp
bolts, spherical nuts, upper and lower floating clamp using a
4mm Hex wrench.
Note: The lower
clamp body may
slide down the
stanchion tube at
this point.
To install the saddle, replace the two saddle head clamp bolts,
spherical nuts, upper and lower floating clamp in the order in
which they were removed.
Before tightening, place the rails of your saddle between the
upper and lower floating clamps so that the rails seat in the
channel provided by the lower floating clamp.
Using a 4mm Hex wrench, tighten the two head clamp bolts until
the desired saddle angle is achived. Then tighten both bolts
evenly to a maximum torque of 10 N-m (8 N-m LEV-Ci.)
SADDLE INSTALLATION
Spherical Nuts
Head Clamp Bolts
4mm
15
17
Spherical Nuts
Upper Floating Clamp
Lower Floating Clamp
Head Clamp Bolts
4mm