Maintenance Of The Device - YATO YT-8300 Manual De Instrucciones

GB
Conservation charging (90% - FULL) – the accumulator is being charged with a conservative current. The microprocessor of the
controller prevents the accumulator from overcharging. Once the process of charging has concluded, the rectifier is automatically
disconnected.
Once the process of charging has concluded, first disconnect the plug of the power cord from the power supply socket, and then
disconnect the terminals of the charging cables.

MAINTENANCE OF THE DEVICE

The device does not require any special maintenance. A dirty housing should be cleaned with a soft cloth or with a compressed
air jet, whose pressure must not exceed 0.3 MPa.
Check the conditions of the terminals of the conductors before and after each use. Remove any signs of corrosion, which might
disturb the flow of the electric current. Avoid contamination of the terminals with the electrolyte from the accumulator, since it would
accelerate the process of corrosion.
The device should be stored in a dry place, away from unauthorised persons, particularly children. Make sure the cables and
conductors are not damaged during storage.
O R I G I N A L I N S T R U C T I O N S
10