Publicidad
Notes: After paging, the number can be added by pressing the key EN for serial call. If you
want to page the same number repeatedly, please keep pressing the key FUN till the
indicator light
number wanted and press the key EN till the indicator light
EN.
3) Keep pressing the key CLR to quit to standby mode after the paging is done.
5. Number Sending Checking (For APE100)
1) Use the key
It means that there is no number sent when 000 appears on the screen.
2) Keep pressing the key CLR till the multi-function pager quit to standby mode.
6. single call or group call debugging (The default setting for the receiver is group call)
】
【For fixed host
screen. Then, press the key [UP] to choose [F5], and press the key [ENT], [00] appears. Use
the key [UP], [MOVE] or [DOWN] to change the number displayed. "00"is for group call and
"01" is for single call.
Other functions of the receiver
◆Sound Setting
1) Standby mode, press the key [FUN] for 3 seconds till [F1] appears on the screen.
2) Use the key [UP] to choose [F2].
3) Press the key [ENT] and [01] appears.
4) Use the key [UP], [DOWN] to choose a type of sound (12 kinds totally).
5) Press the key [ENT], and [F2] appears
6) Press the key [ESC] again and back to standby mode.
◆Display Time Setting
1) Standby mode, press the key [FUN] for 3 seconds till [F1] appears on the screen.
2) Use the key [UP] to choose [F3].
3) Press the key [ENT], and [20] appears on the screen.
4) Use the key [UP], [DOWN] to choose the display time wanted. [00] means unlimited
display, figures 01-99 mean the corresponding time from 1~ 99 seconds.
5) Press the key [ENT], and [F3] appears.
6) Press the key [ESC] and back to standby mode.
◆Sound Length Setting
1) Standby mode, press the key [FUN] for 3 seconds and [F1] appears on the screen.
2) Use the key [UP] to choose [F4].
3) Press the key [ENT] and [01] appears on the screen.
4) Use the key [UP] or [DOWN] to choose the length of sound you want. Numbers 01-15
mean 15 kinds of the length. 01 means 2 seconds, 02 means 4 seconds, and so on.
5) Press the key [ENT], and [F4] appears again.
6) Press the key [ESC] and back to standby mode.
◆Deleting the registered numbers or initializing the receiver
1) Standby mode, press the key [FUN] for 3 seconds till [F1] appears on the screen.
is on, then release the key FUN. Or use the key
or
to check the latest ten numbers sent by the pager on standby mode.
Standby mode, press the key [FUN] for 3 seconds and [F1] appears on the
is on, then, release the key
6
to choose the
Publicidad
