Publicidad
Idiomas disponibles
Idiomas disponibles
1800129688 GV8800 E0 A11_110x154 25/04/13 11:29 Page42
• Holding the iron in a vertical position, tilted slightly forwards, press repeatedly on the steam control button
(underneath the iron handle) moving the iron from top to bottom –
• When the "tank empty" red warning light flashes –
steam. The water tank is empty.
• Remove the water tank and pull horizontally. Fill it up without exceeding the MAX level –
• Replace it fully into its housing until there is a click –
• Press the "OK / RESTART" (depending on model) button
indicator remains lit, the steam is ready.
• The iron of your steam generator comes with a self-cleaning soleplate which functions by catalysis.
• Its unique coating makes it possible to eliminate all the impurities arising from normal usage.
• We recommend you always place your iron on its base or on the iron rest plate in order to protect its self-cleaning
coating.
• Do not use detergent or descaling products for cleaning the soleplate base-unit.
• Never hold the iron or the base unit under the tap.
• Cleaning the soleplate: The iron of your steam generator comes with a self-cleaning
soleplate which functions by catalysis. Its unique coating actively allows it to continually
eliminate all the impurities which are generated every day when the appliance is in normal
use. Nevertheless, using your iron at an unsuitable temperature can leave marks which will
need to be cleaned manually. In this case we advise you to use a soft damp cloth on the
soleplate whilst it is still warm so as not to damage the coating.
• Clean the plastic parts of the appliance occasionally with a soft cloth.
For longer generator life, and to avoid scale emissions, your generator is equipped with a
built-in anti-scale collector. This collector, located in the tank, automatically removes the
scale that forms inside.
:
• An orange "anti-scale" light located on the control panel starts blinking to tell you that the
anti-scale collector needs rinsing -
• Once the generator has cooled down completely, remove the anti-scale collector cap -
• Unscrew the anti-scale collector and remove it from the housing; it contains the scale
that has built up in the tank -
• To clean the collector properly, just rinse it under running water to remove the scale it
contains -
.
• Put the collector back into its housing and screw it in completely to keep it watertight -
.
• Refit the scale collector cover
.
it means that you have no more
, on the control panel to continue ironing. When the green
.
and
.
.
Publicidad
