Assembly - Husky D6TC09001 Guía De Uso Y Mantenimiento

Assembly

A. Mounting the Pegboard back wall to the
Husky 46 in. 9-Dr Mobile Workbench
Model#HOTC4609B11M, SKU#763089
THD.com#1001 712 148
WARNING: Use special care to not over-tighten any of the
screws to avoid damage to the pegboard or mobile workbench.
Attaching this product to your mobile workbench requires drilling
holes into the mobile workbench. Use special care not to damage
the wood top or mobile workbench.
1 . Place the right support post (C) on the back of the mobile
workbench. Ensure the support post is flush and level. Use a
marker to mark the eight holes in the bottom plate which connect
the post to the mobile workbench. Remove the support post (C).
2 . Repeat step 1 for left support post (D) .
C
3 . Using a power drill and 1/8 in. drill bit, drill the eight marked
holes into the sides of the wood top and metal corners of the
workbench. Ensure you drill on a level plane and only 3/4 in.
depth into the wood top and metal sides to avoid damage
to the mobile workbench.
4 .
Repeat step 3 to drill the holes for the other support post (D).
5 .
Attach the right support post (C) to the back of the mobile
workbench using eight self-drilling screws (BB) and a 10 mm
socket. Secure the post but do not tighten the screws at this
time so that the support post has some movement.
6 . Repeat step 5 to attach the left support post (D).
D
7 . Attach the bottom pegboard panel (A) to the support post (C) and
support post (D) using four M6 screws (AA). Secure the
pegboard to the post, but do not tighten at this time.
C
6 6
C
BB
A
D
BB
D
AA