Operation; Care And Cleaning - Husky D6TC09001 Guía De Uso Y Mantenimiento

Assembly (continued)
B.
Mounting the Pegboard panels
directly to a wall
NOTE: Hardware is not included to secure pegboard
panels to a wall.
1 . On a flat level surface, align the long sides of the top panel (A)
and bottom panel (B) together and using a Phillips-head
screwdriver, tighten the three M6 screws (AA) to connect the
panels together.
B
2 . Locate the studs inside the wall where you wish to place the
pegboard and mark them.
3 .
Place the attached pegboard panels on the wall in the desired
location and locate the peg holes over the marked studs on the
wall. Ensure the pegboard is level, then using a minimum 2.5 in.
long screw and 1/2 in. washer, secure the pegboard panels into
wall studs in all four corners at minimum.

Care and Cleaning

□ This steel product has been coated with industrial powder coating
for a durable finish. To help protect this finish, do not allow harsh
chemicals such as oil or grease to remain on the powder coating
surface. Use a glass cleaner ( Windex or equivalent product) to
clean and maintain all powder coated surfaces.
AA
A
®

Operation

The peg holes will accommodate all standard size 1/8 in. and 1/4 in.
peg hooks.
8